TAKE THIS JOB TO YOUR ENGINE
Use the department principles below with the matching engine guide. Select by the installed engine and chassis; model names, engine capacity and appearance alone do not establish compatibility.
Choose engine-specific parts guidance — 11 engine groups
WTN GARAGE / PARTS & MODIFICATIONS
Stopping and rolling hardware: brake-system compatibility, ABS, wheel swaps, bearing/spacer checks, tire fitment and loaded clearance.
BRAKES ARE A MATCHED SYSTEM
Caliper, master cylinder, rotor, pads, hose and mounting geometry work together. Verify the complete combination for the motorcycle rather than buying by piston count or rotor diameter alone. Identify ABS equipment and any required electronic service procedure before opening or modifying the system.
ESTABLISH WHAT NEEDS REPAIR
Lever feel and stopping
Record lever travel, firmness, drag, pulling, pulsing and heat-related behaviour separately. Inspect leaks, hose condition, pad wear and rotor condition using the specified limits. A different pad compound does not repair air or a leak.
Rotor and caliper alignment
Check correct spacers, rotor offset, fasteners and wheel seating. Measure by the manual’s method before blaming a rotor. Inspect bearing play and mounting surfaces when investigating pulsation or uneven pad wear.
FLUID, BLEEDING & ABS
Read the specified fluid type on the applicable documentation and reservoir. DOT 5 silicone and DOT 4 glycol-based systems must not be treated as interchangeable. Use fresh specified fluid and a clean process. Where the manual requires an ABS service function, manual bleeding alone does not replace it.
Follow the pad/rotor maker’s bedding procedure, then verify lever feel, leaks and operation before normal road use. If the required tools, service data or ABS capability are missing, have the system completed by an equipped workshop.
WHEEL SWAPS: VERIFY EVERY INTERFACE
- Axle diameter, bearings, internal spacer and external spacers must form the correct assembly. Confirm any ABS encoder/bearing orientation and sensor gap.
- Verify rotor diameter/offset and pulley or sprocket alignment. The wheel must be correctly centered with the appropriate clearance.
- Check rim width and tire approval, load and speed ratings, tube/tubeless compatibility and valve arrangement. A tire fitting over the rim is not approval for that combination.
- Check tire, fender, belt/chain, swingarm and wiring clearance through the required range of travel, not only with the bike parked.
- Use the vehicle/tire maker’s cold-pressure guidance for the approved fitment and load. Sidewall maximum markings are not a universal everyday pressure setting.
AFTER THE WORK
Record fitted part numbers, measurements, fluid and service operations. Verify wheel rotation, brake release and a stable lever before a controlled low-speed test. Reinspect for leaks, interference and unusual heat. Finish with the specified follow-up checks. Keep any ongoing drag, warning lamp or abnormal feel as an unresolved fault rather than calling the job complete.
PARTS & PRODUCT RESEARCH
Related reports from the Biker Free Press research collection already featured in the WTN Garage. These cover specific applications; inclusion here is not a claim that a product fits every engine or model in this department.
KEEP THE BUILD MOVING
FROM THE SOURCE
WTN workshop research, checked 17 November 2026. These are original planning and diagnostic notes, not a record of WTN product testing. Use the factory service manual and the installed part’s instructions for measurements, procedures and limits.