WTN GARAGE / PARTS & MODIFICATIONS
The WTN parts counter: eight workshop departments covering power, electrics, handling, stopping, driveline, maintenance and the way the motorcycle fits its rider.
START WITH YOUR ENGINE
Pick the actual engine and chassis combination before selecting a part. These eleven build guides connect engine work with induction, electrics, oiling, clutch, suspension and brakes. Each includes three build directions and a practical work-order example.
BUILD THE WHOLE MOTORCYCLE
Engine Parts & Big-Bore Builds
Cams, heads, pistons, cylinders, compression, valve gear and matched engine combinations.
OPEN THE GUIDE →WTN REFERENCE / 02Intake, Exhaust & Tuning
Air cleaners, pipes, carburettors, EFI, sensors, calibration and useful dyno comparisons.
OPEN THE GUIDE →WTN REFERENCE / 03Electrical, Ignition & Charging
No-start diagnosis, batteries, grounds, charging systems, lighting and accessory circuits.
OPEN THE GUIDE →WTN REFERENCE / 04Suspension & Steering
Forks, shocks, springs, sag, damping, steering bearings and changes in ride height.
OPEN THE GUIDE →WTN REFERENCE / 05Brakes, Wheels & Tires
Brake-system matching, ABS fitment, rotors, wheels, bearings, tire clearance and loaded checks.
OPEN THE GUIDE →WTN REFERENCE / 06Clutch, Transmission & Final Drive
Slip versus drag, primary drives, gearing, belts, chains and driveline alignment.
OPEN THE GUIDE →WTN REFERENCE / 07Oiling, Cooling & Maintenance
Oil-system identification, temperature complaints, fluid choices, storage and service records.
OPEN THE GUIDE →WTN REFERENCE / 08Controls, Ergonomics & Touring
Bars, seats, foot controls, luggage, wind protection, wiring reach and whole-bike build planning.
OPEN THE GUIDE →SPEND THE FIRST DOLLAR ON THE RIGHT PROBLEM
01 / Establish condition
Write down the fault or goal, then record engine health, tire/brake condition, charging performance and maintenance history. Worn parts and tuning faults need separating before choosing upgrades.
02 / Choose a useful outcome
Define load, rpm range, terrain, ride duration and fuel availability. “More power” is less useful than stronger roll-on in a stated range with reliable hot starts and acceptable heat.
03 / Build the combination
Price parts, supporting hardware, machining, fluids, labour and calibration together. Confirm fitment by model code and year, then verify what is already installed.
04 / Measure the result
Use comparable before/after conditions. Keep settings, measurements and receipts. Reproduce the original complaint, then inspect for leaks, loose fittings and interference after the work.
THE WTN PARTS-ORDER SHEET
- Bike: model code, year, market, VIN, engine family and any swapped assemblies.
- Goal: complaint or desired improvement, riding rpm, rider/passenger/luggage load and fuel.
- Part: manufacturer, complete part number, instruction revision and written application coverage.
- Dependencies: gaskets, bearings, fasteners, machining, wiring, tuning and special service operations.
- Proof: starting measurement, acceptance limit from the correct document and result after installation.
STAGE LABELS ARE ONLY A STARTING POINT
Stage I, II, III and IV are used differently across brands and generations. Read the actual bill of materials: intake/exhaust, cams, displacement, heads, compression, supporting valve train and calibration. Compare complete packages for the same engine and intended use. A higher stage number does not guarantee a better street motorcycle.
KEEP THE BUILD MOVING
FROM THE SOURCE
WTN workshop research, checked 17 November 2026. These are original planning and diagnostic notes, not a record of WTN product testing. Use the factory service manual and the installed part’s instructions for measurements, procedures and limits.